System information

System Administration Guide

4. In the OfficeSafe section of the screen, enter the IP Address of OfficeSafe PC that is plugged into the

server’s LAN port.

5. Select the Restore from OfficeSafe button.

Note: The PC that will provide the restore image must be running OfficeSafe.

6. Select Accept on the Confirm Restore Request dialog box to begin the restore.

7. Depending on the size of the backup data (and the performance of your network and OfficeSafe PC), it

may take several minutes or perhaps over an hour for the backup to be restored if there are several

gigabytes of data to recover. You will see a “Restore was successful” message in the Status pane on

the Safe Mode page when the operation completes.

8. Select Reboot in Normal Mode and click the Reboot button.

CAUTION: Do NOT select Reboot the Allworx server in Normal Mode with Factory Defaults restored.

This will cause your restored settings to be lost during the reboot. If you do this by

accident, you will want to start the entire restore operation over again.

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

Revised: March 28, 2007

Page 56