Installation guide

48x Server Installation Guide
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx is a registered trademark of Allworx Corp. All other names may be trademarks or registered
trademarks of their respective owners.
Version: 1. Revised: July 15, 2010
Page 9
5 Electrical
5.1 Power Connection
Warning: Failure to follow these steps may result in equipment damage, personal injury, and a voided
product warranty.
Insert the female end of the power cord into the receptacle on the rear of the unit. Connect the other end to
the power source. The product is rated 115/230 VAC, 1/0.7A, and 50/60Hz. The Allworx server will
automatically begin to power up once the power has been stable for a few seconds. This is part of the design
to automatically boot up after a power failure.
5.2 Chassis Ground
Warning: Failure to follow these steps may result in equipment damage, personal injury, and a voided
product warranty.
To help prevent electrical shock, the separate protective earthing terminal, located next to the power jack on
the rear panel, must be permanently connected to earth using 18 AWG wire or larger. (See Figure 2, item 14)
5.3 Power-Up Sequence
As the Allworx server progresses through the power up sequence, the front panel lights will respond as shown
in Table 2.
Front Panel Light Power-Up Sequence Description
Power
Flashes green as the power up sequence
progresses; steady green when the unit is ready.
Activity – INT
Solid green when internal drive mounted; blinking
light indicates activity.
Activity – EXT
Solid green when USB device attached and enabled;
blinking light indicates activity.
Table 2: Front Panel Lights During Power-Up Sequence