User`s guide

Phone Guide – 9224
Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
Revised: April 16, 2013
Page 10
Note: The Allworx Server Administrator may configure this method for server
7.4 and greater based on the phone configuration.
1. Press the TRANSFER button. This places the current call on hold.
Key System Mode: To transfer a call to an external party, press a free
Line Appearance PFK, and then dial the phone number.
PBX Mode: Continue to step 2.
2. Wait for the dial tone, and then dial the number to transfer the call.
3. Hang up, press the TRANSFER button, or press the XFER softkey to
complete the transfer. 0.
To do an Announced (Attended) transfer:
1. Press the TRANSFER button. This places the current call on hold
2. Select an unused Call or Line Appearance PFK.
3. Dial the number of the recipient of the transfer.
4. Talk to the recipient.
5. Press the TRANSFER button again, and then press the PFK of the
original call. This connects the two parties.
6. Hang up the handset when finished.
0.
To cancel the transfer, press the RELEASE button. To return to the
original caller, press the PFK indicating the held call.
Allworx Server Software 7.4 or Higher
Note: Verify the INTERCOM button or an appearance PFK is free.
To do a one-step transfer:
On an active call, the user must have a BLF or Speed Dial PFK for the
recipient of the transfer (Note: The Allworx Server Administrator enables the
one-step transfer).
1. Press the BLF or Speed Dial PFK for the recipient of the transfer.
Unattended (Blind) Transfer: skip to step 2.