User`s guide

Allworx Server Administrator’s Guide Version 7.6
1-866-ALLWORX * 585-421-3850 Page 57
www.allworx.com
Revised: 11/22/13
6. Press the EXIT soft key repeatedly until the system prompts to save the settings.
Press the YES soft key.
7. Press the CONFIG soft key to reboot the phone, use the arrow keys to highlight
Reboot Phone, and press the Select button . Answer Yes to the confirmation.
The phone reboots and connects using the DHCP and manually entered settings.
10.1.3 VLAN Settings
If the network site uses VLANs, additional configuration is necessary. If the network
Settings VLAN is set to Auto Configure and connected to a switch port that does not
support a discovery protocol, change the setting to Manual to reduce the phone boot
time.
Allworx phones running firmware from server software release 7.2 or higher (phone
firmware version 2.2 or higher) default to VLAN auto configure. If the network utilizes
LLDP-MED or CDP to set network host VLAN configurations, this properly configures
the Allworx phones. If the phone is running an earlier version of firmware or if the
network does not use LLDP-MED or CDP, configure the VLANs manually.
To configure VLANs on the phone:
1. Press the CONFIG soft key on the phone.
2. Use the arrow buttons to highlight Network Settings and press the Select button
. If prompted for a password, enter allworx using the numeric keypad, and
then press the Select button . The Network Settings menu displays and DHCP
highlights.
3. Use the arrow keys to highlight VLAN. Press the Select button until the VLAN
setting is Manual.
4. Use the arrow buttons to highlight Phone VLAN Settings. Press the Select button
.
5. Enter the value for Phone VLAN ID, and press the Select button .
6. Enter the value for Phone VLAN Priority, and press the Select button .
7. Use the arrow buttons to highlight PC VLAN Settings.