User`s guide

Allworx Server Administrator’s Guide Version 7.6
Page 56 1-866-ALLWORX * 585-421-3850
www.allworx.com
Revised: 11/22/13
4. Press the EXIT soft key repeatedly until asked to save the settings. Press the
YES soft key.
5. Press the CONFIG soft key to reboot the phone, use the arrow keys to highlight
Reboot Phone, and press the Select button . Answer Yes to the prompts. The
phone reboots and connects using the DHCP and manually entered settings.
10.1.2 Static IP Addressing
If assigning the phones static addresses rather than using DHCP, manually enter the
following network settings on the phone:
• Boot server (the Allworx server IP address or domain name)
• Time Server (optional, can be an IP address or domain name)
• DNS Server IP
• Phone IP
• Netmask IP
• Gateway IP
To update the Static IP Address:
1. Press the CONFIG soft key on the phone.
2. Use the arrow buttons, highlight Network Settings, and press the Select button
. If prompted for a password, enter allworx using the numeric keypad, and
then press the Select button . The Network Settings menu displays and DHCP
highlights.
3. Press the Select button until the DHCP setting is Disabled.
4. Use the arrow keys to highlight Edit Boot Server. Press the Select button .
Using the phone’s keypad, enter the IP address or the domain name of the
Allworx server. Use the asterisk key (*) for periods. When done, press the Select
button .
5. Highlight, select, and enter the remaining settings from the list above.
Note:
To abort an Allworx phone boot cycle, press the MUTE/DND button three times. If the
phone is running firmware from server software release 7.3 or lower (phone firmware
version 2.3 or lower), press the RELEASE button three times.