User`s guide

Allworx Server Administrator’s Guide Version 7.6
1-866-ALLWORX * 585-421-3850 Page 43
www.allworx.com
Revised: 11/22/13
To disable Multi-site on all servers:
1. Login to the Allworx server admin page, navigate to Network > Multi-Site >
modify, and locate the Configuration section.
2. Click the Disabled button.
3. Click the Remove links on all servers to remove all site data on all servers.
4. Navigate to the Phone System > Dial Plan > Internal Dial Plan section, and
click the modify link.
5. Confirm that the Internal Dial Plan is identical on all servers - Normal or Extension
Mode.
6. Reboot all phones, and enable Multi-site on the Primary site.
a. Navigate to Network > Multi-Site > modify.
b. Locate the Configuration section, and click the Controller Site button.
7. Enable Multi-site on all of the Branch sites and Accept all sites into the network on
the Primary site.
a. Navigate to Network > Multi-Site > modify.
b. Locate the Configuration section and click the Branch Site button.
8. Verify that the multi-site network is operating properly. Run the Multi-site Tests on
the Network > Multi-Site page and place calls between all combinations of
servers.
7.3 Important Notes
To examine the configuration:
1. Login to the Allworx server admin page and navigate to Phone System >
Handsets.
Note:
If installing Generic SIP phones on the system, Internal Dial Plan changes can
modify the configuration on the server such that the Generic SIP phones no
longer register.