User`s guide

Allworx Server Administrator’s Guide Version 7.6
1-866-ALLWORX * 585-421-3850 Page 193
www.allworx.com
Revised: 11/22/13
6. Click Install. After a successful installation, locate the Server Language
Configuration, and click the Modify link.
7. Select the new language for the Primary or Secondary language.
8. Select a second available language (e.g. US English) as the Primary or
Secondary language, and then click Update. The Languages page is displays.
9. Navigate to Maintenance > Restart and select Normal restart for the changes to
take effect.
10. Log in to the Allworx server admin page, and navigate to the Languages page.
Verify the language configurations. Using the procedures below, configure the
system behavior.
28.2 Language Settings
28.2.1 Outside Lines
Each outside line has a default language. When receiving calls over an outside line, the
system assigns the default language for that line. Thereafter, when the call reaches
some applications within the server (e.g. Auto Attendant, Queue), the system uses or
overrides the outside line language, depending on the application’s language setting.
Outside line default language can be set in the following locations:
• CO Line
• SIP Proxy
• SIP Gateway
• DID Routing Plan – Default route
• DID Routing Plan – Mapped extensions
• Digital Lines – Each line
Default Language choices:
• Primary –the prompts play in the system Primary language.
• Secondary –the prompts play in the system Secondary language, if installed.
• Use Source (DID Routing Plans only) –the prompts play in the language
choice set for the outside line using the DID Routing Plan. For example, if a SIP