User`s guide

Allworx Server Administrator’s Guide Version 7.6
Page 114 1-866-ALLWORX * 585-421-3850
www.allworx.com
Revised: 11/22/13
13.4.7 Restrictions
Designate one interface as the logical WAN interface for the 24x and 48x systems. Use
only the Ethernet WAN port or one of the T1 interfaces for routing TCP/IP traffic. Select
either Ethernet WAN, T1-A, or T1-B ports as the data WAN interface for the system even
though it is possible to provision multiple interfaces simultaneously.
13.4.8 Configure Digital Lines
The service provider provisions the line to the interface, which dictates the configuration
of the Digital Lines.The settings must match the service provider’s expected
configuration or improper operation will result. Fully configure the line or lines in use
before physically connecting the server to the T1 line.
Configuration Hint
When using a Digital Line for circuit switched voice operation (PRI or RBS modes), the
preferred method is to set all the Digital Line parameters including the functional
definition for each time slot on T1 line. After setting this configuration, each slot
configured to support circuit switch voice calls display as a new outside line. That is,
logically treat each separate slot configured for circuit switched voice calls as a separate
telephone line. At that point, details of the line routing or configuration are set under the
Digital Lines section found on the Phone System > Outside Lines configuration page.
Parameters for each Digital Line are configured on the Network > Digital Lines >
Modify page for the specific line to configure. It is important to provision Digital Lines not
in use as Disabled. The disabled state is the factory default setting for each T1 line.
Parameter Description
Description
Description of the Digital Line interface. Use this description in all other
places referring to this line, such as in the Outlines Lines view and
configuration pages of the phone system.
Line Mode
The provisioned operational mode for this interface. Currently, only T1
mode and Disabled are available. In the future, additional options may
be available such as E1 and J1 for use in international markets outside
of North America