User`s guide

Allworx Server Administrator’s Guide Version 7.6
1-866-ALLWORX * 585-421-3850 Page 103
www.allworx.com
Revised: 11/22/13
device as soon as it answers the call. The following characters are available for
use:
DTMF digits:
•0 – 9
•A – D
•*
•#
Timing controls:
• P generates a one second pause
• + increases the duration and gap of all DTMF tones by 50ms
• - decreases the duration and gap of all DTMF tones by 50ms
Variables:
• $xN sends the last N digits (0 for all digits) of the dialed extension
• $nN sends the last N digits (0 for all digits) of the DNIS number
For the device to receive incoming calls, route an outside line to the attached device
port.
To route an outside line to the device:
1. Create an extension that rings the port of the device.
2. Route an outside line to the extension.
13.3 SIP Proxies and SIP Gateways
The Allworx servers support connectivity to external SIP-compliant devices such as
Internet Telephony Service Provider (ITSP) servers and SIP gateways. The Allworx
products interface with four different types of SIP devices based the ability to interact
with the Allworx system.The 6x12 servers do not support SIP Gateways.
Note:
For specific device setup instructions for the Multi-Tech FaxFinder, please refer to the
application notes located on the Allworx Partner Portal at www.allworxportal.com
.
Sip Device Description
SIP Proxy
Refers to a SIP Trunk, an external SIP service for routing calls. Access the SIP
Proxy through the Internet or through the wide area network (WAN). To connect
to a SIP proxy (or ITSP), configure the SIP Proxy on the Allworx server.
Application notes for configuring Allworx servers with approved ITSPs are
available on the Allworx Partner Portal www.allworxportal.com
.