User`s guide

System Administrator’s Guide – Release 7.2.3.x
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx, a wholly owned subsidiary of PAETEC Holding. All other names may be trademarks or registered
trademarks of their respective owners.
Revised: September 1, 2010
Page 84
As instructed on the page, enter the firewall’s public IP address in the Public IP Address field. In addition, it
may be necessary to configure the firewall to statically map specific ports. This is described in the NOTE box
on the web page and is discussed further, below.
14.3 Setting Up Remote Allworx Devices
Configuring a remote phone or port expander requires setting two configuration parameters on the device.
The first parameter is the Boot Server IP. This is normally the IP address of the Allworx
server’s WAN port.
That can be obtained from the server’s WAN TCP/IP Address parameter on the Network / Configuration
page. However, if the Allworx
server network mode is set to LAN Host, then this value will be the Public IP
Address parameter on the Network / Configuration page.
The second required parameter is the Plug ‘n’ Play Secret Key. This key is displayed on the Servers / VoIP
page on the server: