User`s guide
System Administrator’s Guide – Release 7.2.3.x
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx, a wholly owned subsidiary of PAETEC Holding. All other names may be trademarks or registered
trademarks of their respective owners.
Revised: September 1, 2010
Page 30
Select the phone model and fill in the required fields.
8.1.3.1 Allworx Phones
For Allworx phones, follow these steps:
1. Change the Model to the appropriate selection for the phone that is to be configured.
2. Enter a Login ID and Password for the phone to use to authenticate with the server.
Note: The Login ID must be unique; cannot use the same Login ID on multiple phones.
3. Enter the correct MAC Address for the phone.
Note: If this is not correct, then when the phone is booted on the network, the server will have a
duplicate entry for this phone because it will plug-and-play register itself with the system using
the correct MAC address.
4. Enter the other parameters, as necessary.
5. Click the Add button to add the new handset to server.
8.1.3.2 Generic Phones
If the phone is not an Allworx
IP phone, follow these steps:
1. Change the Model to Generic SIP.
2. Enter a Login ID and Password for the phone to use to authenticate with the server.
Note: The Login ID must be unique; cannot use the same Login ID on multiple phones.
3. Click the Add button to add the new handset to server.
4. Configure the phone (following its particular configuration instructions) with the User ID (shown on the
updated Phone System / Handsets page), Login ID, and Password.
When the phone is registered with the server, its entry on the Handsets page will indicate that by showing an
expiration date and time.
8.2 Analog Phones
Plug the phone into one of the server’s FXS phone ports reserved for Inside Phone Extensions. Lift the phone
receiver so that the phone is off hook. Refresh the browser window. Your phone will now appear in the
Analog Handsets section of the page. Hang up the phone receiver.
Analog phones that are plugged into Port Expander FXS ports do not automatically appear on the Handsets
page. They must be added, manually.