User`s guide

System Administrator’s Guide – Release 7.2.3.x
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx, a wholly owned subsidiary of PAETEC Holding. All other names may be trademarks or registered
trademarks of their respective owners.
Revised: September 1, 2010
Page 124
If you change the names of any Paging Zones, any handsets with a PFK defined for those Paging Zones will
not use the new name until the handset has been rebooted.
26.3 Paging Zone Operation on the Handsets
Each applicable lineout and Allworx handset can be added to or removed from each of the paging zones. By
default, each applicable lineout and handset are enable for paging zone 0 and disabled for all others. The
paging zones can also be enabled and disabled on the handset configuration page. The handsets can be
configured to one of the following relative to all pages received:
• Pages always accepted.
• Pages accepted only while on hook.
• Pages never accepted.
If you change the zones for a handset, it is necessary to reboot the handset for the changes to take effect.
†
Extensions may vary per system. If you are using a non-default Internal Dial Plan, consult the Phone Features tab of the
My Allworx Manager page to determine what extensions are being used for the corresponding feature.