Installation guide

24x Installation Guide
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be
trademarks or registered trademarks of their respective owners.
Revised: February 7, 2007
Page 12
7 Ethernet Connectivity
The Local Area Network (LAN), Wide Area Network (WAN), and Demilitarized Zone (DMZ)* data network ports
are 10BaseT/100BaseTX auto-sensing and auto-MDI/MDIX ports.
SIP phones connect to the server just as any other data network device. The phones and the server need to be
properly configured. See the
Server Configuration (Section 6) for more information.
The Allworx 24x is a sophisticated network appliance that must be properly configured before being connected
to the LAN, WAN, and DMZ
*.
Note: Do not plug any network or ISP service into the server without first properly configuring the server.
Failure to heed this warning may result in a disruption of network connectivity with other equipment on
the network.
After the unit is properly configured, the LAN, WAN, and DMZ
* network infrastructure cables can be plugged
in. Standard RJ-45 category 5 network cables must be used.
The LED’s on the LAN, WAN, and DMZ
*
ports are defined in Table 4.
LED Identification State Description
Off No link: the network is not connected
On Link: the network is successfully connected
Green
Blinking Activity: data is being transmitted or received
Off Speed: 10MB/S
Amber
On Speed: 100MB/S
Table 4: Network Port LED Definitions
*
Future Feature