Installation guide

24x Installation Guide

4.3 Wall Mount

Note: For wall mount installations, discard included power cord and use only a UL listed power cord of type

SJ or SO or better.

To mount the Allworx 24x on ½” drywall:

1. Verify that there is sufficient clearance around the server’s front and rear panels to allow power, network,

and telephony connections. Place the brackets on each side of the unit so that the smaller face of the L-

Bracket is facing down (See Figure 4).

2. Install the mounting brackets on each side of the server chassis using the four 6-32 flat head screws.

3. Use 50lb self-drilling drywall anchors rated for at least 20 lbs with screws that are either #6 or #8. Locate

two anchors that will support the upper end of the unit using the wall mount diagram. Install the anchors

per the anchor manufacturer’s recommendation. Install the mounting screws through the bracket holes

and into the anchors.

4. Tighten screws so that Allworx server is secured firmly against the wall.

Caution: The Allworx server must be securely mounted to the wall to avoid equipment damage or

personal injury.

Note: The unit must be mounted with the front facing left or right, not up or down (See

Figure 5).

Figure 4: Wall Mount Bracket Installation

300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com

trademarks or registered trademarks of their respective owners.

Revised: February 7, 2007

Page 7