Instructions / Assembly

ManualsBrandsALLURE ManualsDecorative Wall Paneling5 in. W x Multi-Length Dark Pine Peel and Stick Vinyl Wall Plank (20 sq. ft./case)

Revised April 14, 2021

Introduction

Allure Decorative Wall Planks are unique, decorative, wood-look vinyl planks designed for interior walls and ceilings. Strong, lightweight and

flexible, Allure is easy to install, as each plank comes with pre-attached, self-stick, super-grip tape that's made in the USA.

Install Allure Decorative Wall Planks as accent-walls, wainscoting, interior columns, around island or peninsula cabinets, headboards,

ceilings and much more. Let your imagination be your inspiration.

Safety Information

Power tools are not required to cut Allure planks. However, those who prefer the use of power tools (e.g. electric saws) should wear the

proper safety equipment. Such equipment includes: safety glasses, dust mask and gloves.

Pre-Installation Information

■ Tools required:

• Utility knife with several new blades

• Tape measure

• Square

• Chalk line

• Pencil

• J Roller (a roller)

■ Install in interior, temperature-controlled environments only!

• Do not install in saunas, showers or tub surrounds,

sunrooms, seasonal porches, and all exterior installations

■ Acclimate product for 24-48 hours at room temperature

of 60°F to 85°F (15°C to 30°C). HVAC system should be

operational before, during and after installation

■ Store product horizontally in a dry area away from direct

sunlight or heating and cooling ducts. Do not remove planks

from cartons during storage or acclimation

■ Post installation temperature ranges must be maintained

between 50°F to 95°F (10°C to 35°C)

■ Pre-attached, self-stick tape requires 24-48 hours to achieve

full bond once planks have been installed

■ Approved substrates:

• Ceramic tile

• Concrete (smooth)

• Plywood – smooth, no knots

• Sheetrock – unpainted or painted (latex paint or primer)

• Textured surfaces (e.g. orange peel, see note on page 3)

• Wall paper (paper or vinyl) in good condition and fully

adhered to wall with no peeling. Remove wall paper in bad

condition

■ Non-approved substrates:

• Brick

• Cinderblock

• OSB (Oriented Strand Board)

• Popcorn ceilings

• Rough concrete

■ Prepping for installation:

• Remove any electrical switches, outlet plates and light

fixtures that may interfere with the installation

• Remove ceiling and base board trim (if desired)

• Fill voids with spackle/joint compound; honor

manufacturer's recommended drying times before

proceeding with installation

• Surfaces must be smooth, clean, dry, and free of dust and

foreign matter. Remove dirt, dust, oils and loose paint. For

best results, the substrate should be as smooth as possible.

If necessary, clean the surface with a 50/50 mixture of

isopropyl alcohol and water. Then, dry with a lint-free cloth

Installation, Care Guide, and Warranty

Wall Planks

This document supersedes all printed and electronic installation and technical guides previously distributed by Halstead.

Summary of content (10 pages)

PAGE 1
Wall Planks Installation, Care Guide, and Warranty Introduction Allure Decorative Wall Planks are unique, decorative, wood-look vinyl planks designed for interior walls and ceilings. Strong, lightweight and flexible, Allure is easy to install, as each plank comes with pre-attached, self-stick, super-grip tape that's made in the USA. Install Allure Decorative Wall Planks as accent-walls, wainscoting, interior columns, around island or peninsula cabinets, headboards, ceilings and much more.
PAGE 2
Design Options HORIZONTAL VERTICAL DIAGONAL CHEVRON WAINSCOTING Revised April 14, 2021 2
PAGE 3
Installation The steps below represent a wall installation using the traditional Horizontal design option as seen in the previous section (Design Options). Use these same steps for a ceiling installation.
PAGE 4
Care & Maintenance and Useful Tips ■ To clean, use a non-abrasive, all-purpose cleaner with paper towels or a clean cloth ■ Do NOT use cleaning products that contain bleach, strong chemical detergents, abrasive cleaners or scouring pads ■ Hanging pictures – fasteners must go through the planks into the substrate or wall studs ■ The use of longer screws may be necessary when replacing electrical outlets and switch covers NOTE: Textured surfaces (e.g.
PAGE 5
Warranty, continued ■ Installations in saunas, sunrooms, solariums, boats, campers or RV’s ■ Scratches or damage caused by handling or instruments ■ Peeking of edges (white line) ■ Minor shading, color or texture differences between samples, replacement planks, printed materials, photographs or illustrations and delivered product ■ Products sold as irregulars or trial grade materials or “as is” ■ Damage caused by misuse of product (including installation of Allure as flooring) ■ This Limited Warranty is voi
PAGE 6
Tablones para Paredes Instalación, guía de cuidados y garantía Introducción Los tablones decorativos para paredes Allure son tablones de vinilo únicos, decorativos, con apariencia de madera, diseñados para paredes y techos interiores. Resistente, liviano y flexible, Allure es fácil de instalar, ya que cada tablón viene con cinta adhesiva de súper agarre pre-adherida que se fabrica en los EE. UU.
PAGE 7
Opciones de diseño HORIZONTAL VERTICAL DIAGONAL CHEVRON REVESTIMIENTO CON PANELES DE MADERA Spanish Revisado April 14, 2021 2
PAGE 8
Instalación Los pasos a continuación representan una instalación de pared utilizando la opción de diseño horizontal tradicional como se ve en la sección anterior (Opciones de diseño). Sigue estos mismos pasos para una instalación en el techo.
PAGE 9
Cuidado y mantenimiento y consejos útiles ■ Para limpiar, usa un limpiador multiusos no abrasivo con toallas de papel o un paño limpio ■ NO uses productos de limpieza que contengan lejía, detergentes químicos fuertes, limpiadores abrasivos o estropajos ■ Cuadros colgantes: los sujetadores deben atravesar las tablas hasta el sustrato o los montantes de la pared ■ Puede ser necesario el uso de tornillos más largos al reemplazar los enchufes eléctricos y las cubiertas de los interruptores NOTA: Las superficies
PAGE 10
Garantía (continuación) ■ Instalaciones en saunas, soláriums, barcos, remolques o autocaravanas ■ Arañazos o daños causados por la manipulación o los instrumentos ■ Descascaramiento de los bordes (línea blanca) ■ Diferencias menores de sombreado, color o textura entre muestras, tablas de reemplazo, materiales impresos, fotografías o ilustraciones y producto entregado ■ Productos vendidos como irregulares o materiales de prueba o “tal como está”.