Instructions / Assembly

6. Install handles with provided screws.
7. The roller catch may need adjustment for the
door to open and close properly. Using a 2.5 mm
allen key, adjust the roller in or out at the hole just
below the roller.
8. The hinges allow for horizontal and vertical
adjustments to the door. To make adjustments,
loosen the two large screws shown above using a
T-25 bit. This allows the hinges to freely and safely
move in the next step.
9. Use a T-15 bit at the location shown above to
make adjustments. To make horizontal
adjustments, turn the center screw. To make
vertical adjustments, turn the screw next to the
center screw. Once adjustments are complete,
make sure to tighten the screws that were
loosened in step #8.