Manualshelf

Instructions / Assembly

ManualsBrandsAllure Walk In Tubs ManualsBath5 ft. Right-Drain Walk-In Bathtub in White
11121314151617181920
1. Fill the tub with WARM water 2-3 inches above the jets. Add 1/4 to 1/2 box of baking soda to the
bathtub water.
2. Turn on jet massage system and run for 10 minutes.
3. Drain tub.
4. Fill tub with COLD water 2-3 inches above jets.
5. Turn on water jet system and run for 10 minutes.
6. Drain tub.
7. Run air jet system for 1-2 minutes to clear out lines.
8. Use a mild liquid household detergent such as or a spray-on aerosol cleaner designed for use on
fiberglass or acrylic tubs, and wipe with a clean soft cloth. A soft bristled brush may be used in the
textured areas of the slip-resistant floor if necessary.
18
CLEANING AND CARE
SUCTION COVER (Jetted Bathtubs Only)
Remove any hair, lint, or soap residue from the suction cover. An old toothbrush is especially good at
cleaning soap scum from the holes in the suction cover.
On a monthly basis, unscrew the suction cover and clean away any hair, lint or debris from the cover and
housing, then remount the cover in place.
The water and air jet systems should be cleaned before first use and on a monthly basis afterwards while
the bathtub is in normal use.
NEVER OPERATE THE WATER JET SYSTEM
WITH THE SUCTION COVER OFF!
NEVER USE ABRASIVES OR POWDERED CLEANSERS. They will scratch and dull the surface.
Always use a mild liquid household detergent such as or a spray-on aerosol cleaner designed for use on
fiberglass or acrylic tubs. Test on a small area for the cleaner’s effect on the finish. DO NOT USE METAL
SCRAPERS, WIRE BRUSHES OR OTHER HARSH ABRASIVE TOOLS.
Never use bleach when cleaning the surface or the jet systems.
Light scratches and dulled areas may be restored to original luster by polishing with an automotive type
rubbing compound designed for use with fiberglass and gelcoat. Stubborn debris or construction adhesive
residue may be removed with denatured alcohol.
SURFACE CLEANING
FADING
Avoid locating your bathtub where it will receive continuous direct sunlight. Continued exposure to the
sun’s UV rays can cause yellowing, fading or discoloration.
WATER JET SYSTEM (Jetted Bathtubs Only)