Instructions / Assembly

17
AIR JET SYSTEM
WATER LEVEL TOO LOW:
OVERSPRAY FROM JETS
CORRECT WATER LEVEL:
JETS FUNCTION CORRECTLY
JETS
WATER LEVEL TOO LOW:
JETS WILL NOT FUNCTION
The sensors for the Water Pump are the small
silver studs located beneath the water jets on
the seat backrest.
WATER JET FUNCTION
NOTE: Ensure that the water level in the tub is above the sensors and
water jets in the back rest (see illustration). If water level is too low,
overspray may occur, or the water pump may not function.This is a
safety feature designed to prevent damage to the water pump.
The Inline Heater is pre-programmed to maintain a water temperature of 104
o
F. It is not designed to raise
the temperature of cold bathwater, but to maintain the water temperature while running the water jet
system. It is activated automatically when the water jet system is turned on, senses the current water
temperature, and turns on and off automatically as needed to maintain this temperature. Please note that the
Inline Heater will not operate unless the water jet system is turned on, as the water must circulate through
the heater for it to be effective.
INLINE HEATER FUNCTION
The Air Jet system injects air into the bath from a number of fittings to create a soothing massage. The air
jets can be run in conjuction with the water jets or separately.
NOTE: After every bath, and after the bathtub has been drained, the
air jets should be run for 1 to 2 minutes, whether they were used
during the bath or not. This will clear the lines and prevent mildew.