Instructions / Assembly

1
2
5
6
7
3
4
8
Assembly of the spigot is as follows: Insert spigot body (1) and trim ring (2) from above
through hole in tub deck (4). Be sure locating pin (8) is aligned correctly with small hole in tub
deck. Install rubber washer (5) , steel washer (6) and retaining nut (7) on spigot valve body
(3). Thread the spigot valve body through trim ring and tighten into spigot body. Tighten
retaining nut. Do not overtighten. All threads should be wrapped with Teflon
®
tape prior to
assembly.
10
Operation of the Diverter Valve (to
change water flow from Spigot to Hand
Shower) is done by raising or lowering
the Diverter Stem on the rear of the
Spigot, as shown at left.
SPIGOT ASSEMBLY
1. Spigot body
2. Trim ring
3. Spigot valve body
4. Tub deck
5. Rubber washer
6. Steel washer
7. Retaining nut
8. Locating pin