Installation Instructions
Allura Fiber Cement Siding Installaon Manual
51
Laced Corners
To c re a t e a l a c e d (o r p r a i r i e - s t y l e) c o r n e r :
Flash all corners. Allura recommends installing prefinished metal flashing that
extends a minimum of 10” on each side.
Install the first board flush with the corner of the sheathing.
Install the board on the intersecting wall so that it overlaps the width of the
previous board.
Reverse this pattern on the next course of siding.
As you work your way up the wall, alternate the pattern, so the joint lines between
the corner boards are staggered.
Seal the exposed edges of the siding so that they do not absorb moisture.
NOTE: Do not use prefinished product to create laced corners.
Secon 11: Shapes Siding
Before you install the siding, review and comply with all local building codes and
regulations regarding wall construction including the proper use of sheathings, framing,
weather- resistant barriers, flashings and other building materials and systems.
Before You Begin
Review the general cutting, fastening, and wall preparation instructions in the Cutting,
Fastening, and Wall Preparation sections. Some important reminders:
Cut fiber cement shapes face down with mechanical shears or a circular saw. To
prevent marring the surface of the siding, cover the saw table with a carpet or
other soft material.
Prime, paint or caulk all field-cut edges of siding.
Do not prime or paint the back of the panel. Refer to instructions on butt joints and
trim locations for specific requirements.