Installation Instructions
Allura Fiber Cement Siding Installaon Manual
24
Proper Cutting Setup
Use good support and position the siding face down when using a circular saw or
mechanical shears.
Cut fiber cement board face up when using a chop/miter saw.
When cutting fiber cement, support the board along its length and near the cut.
To a vo i d b re a k a g e , u s e e x t ra c a r e w h e n y o u c u t n e a r t h e e d ge .
Leave Protective Film on Cedar Lap Siding with Allura
ColorMax
®
Finishing System until board is installed.
Handle narrow and notched pieces carefully to avoid breakage.
When cutting beaded siding profile, start the cut against the bead.
When cutting Allura Fiber Cement Cedar Lap Siding with Allura ColorMax
®
finish,
leave the protective film in place until the siding is nailed to the substrate; then
remove it before applying the next course.
NOTE: Always re-seal all field-cut edges with
100% acrylic latex paint or primer before
installing fiber cement.