Installation Instructions
Allura Fiber Cement Siding Installaon Manual
16
More information about personal protective equipment is available at www.osha.gov/
SLTC/personalprotectiveequipment
Consult the Material Safety Data Sheet (MSDS) on our website www.AlluraUSA.com
and a qualified industrial hygienist for further health and safety information related to
this product.
Air Compressors
Air compressors can be very dangerous and cause serious injury if used improperly, so
before you begin to use your air compressor, set it up properly to ensure safe operation.
Locate the air compressor in an area that is free and clear from dust and debris.
Excessive dust and debris will clog the filter and may even damage the internal
components of the compressor.
Limit the length of hose and the number of splits between the compressor and
the nail gun.
Set the air pressure regulator on the air compressor to the appropriate PSI setting
and test the pressure for over/under driving the fastener on a scrap piece.
NOTE: Always turn the air compressor off and drain the air out of the tank before
connecting or disconnecting air tools. Failure to do this may result in serious injury.
Secon 4: Storage and Handling
Fiber Cement must be kept covered and stored off the ground, on a clean, flat, and
level surface. Before it is installed, fiber cement should also be protected from direct
exposure to the weather. Allura recommends that pallets be stored in a garage, under
a protected area or under a tarp because Allura Fiber Cement Siding that is wet can
become heavy and more flexible, making it difficult to carry and install. Also, the joints
between the panels can swell or shrink if fiber cement gets wet before it is installed. If
Allura Fiber Cement Siding becomes wet, it must dry completely prior to installation.
NOTE: Do not install fiber cement material that is wet. Installing wet or saturated
boards may result in the butt or end joints shrinking or swelling after installation.
Proper Storage
Allura Fiber Cement Siding is coated with our sealing system to protect against
moisture. However, even with this sealer, the product can become saturated if not
protected during storage. If fiber cement becomes saturated, do not install it until it
dries out thoroughly.