Installation Instructions

FASTENERS:

 Fasteners must be corrosion-resistant; preferably quality hot dipped galvanized nails. MAXITILE is not responsible

for corrosion resistance of fasteners.

Stainless steel fasteners are recommended when installing MAXITILE products

near the ocean, or in very humid

climates. Always check local building c

odes

for additional requirements.

 Screws shall be self-drilling all weather or stainless steel.

 Staples are not allowed.

 Installation into wood stud:

 Nails must always hit studs, penetrating a min. of 1-inch into stud.

 Nails can be applied using a smooth head hammer or a pneumatic

nail gun with ush attachment so that nails are not over-driven.

 If you are hand-nailing near corners, pre-drill the holes to avoid

accidental breakage.

 For wood frame construction, a minimum of 4d common nai

ls x 1 ½” long spaced 8” O.C. (on center) at panel edges,

and

intermediate framing studs spaced up to 24” on center are suitable in most locations.

 For conventional 20ga steel frame construction a m

inimum No. 8-18 x 0.323” HD x 1” long ribbed bugle screws

spaced 6” o.c. at panel edges and intermediate framing members spaced up to 24” on center are suitable in most

locations.

 Drive fasteners perpendicular to siding and framing.

 Do not over-drive nail heads or drive nails at an angle.

 If nail is countersunk, caulk nail hole and add a nail.

 Do not use aluminum fasteners, staples, or clipped head nails.

NOTE: Published wind loads may not be applicable to all areas where Local Building Codes have sp risdiction. Consult MA XITILE Technical

Assistance if you are unsure of applicable compliance documentation.

Pneumatic Finishers Gun

with Flush Attachment

Incorrect Correct

FRAMING:

 MaxiSOFFIT

panels may be installed over either wood or steel framing complying with the Local Building Codes.

www.maxitile.com |

MaxiSOFFIT

Remember: Fastener always must be attached to structural framing members.

O.C.