Installation Instructions

Allura Fiber Cement Siding Installaon Manual

Keyways Line Up with Center of Tab

4. Finis installing te irst ourse to te rigt and let sides leaing  gas beteen

the trim and the side of the first and last panels.

5. Always caulk between the siding and the trim.

Second Course

1. Starting at the left side, locate the first full panel installed on the first course.

2. set te nd ourse   tabs rom te irst ull iee is oriontal sit

will vertically align the center of each tab on the 2nd course with the keyways of

the 1st course.

3. To achieve proper exposure, you can measure up 7” from the top of the panel and

make a mark on the wall. Then place the top of the next course/panel on the mark

that you made and nail. Or measure down 7” from the top of the next panel and

make a mark on the edge of the panel. Then align the mark on the edge of the

panel with the top of the installed course and nail.

4. Fasten the panel as directed for the first course.

NOTE: Make sure the tops of the keyways are concealed by the overlapping panel

before fastening the siding.

Subsequent Courses in Wall Areas

1. Install the 3rd, 5th, and all other odd courses in the same horizontal position as the

1st course. Leave a 7” exposure.

2. Install the 4th, 6th, and all other even courses in the same horizontal position as

the 2nd course. Leave a 7” exposure.

3. When a window or doorway breaks a course, continue the application as if the

opening did not exist.