User's Manual

42
“Connect GPS Receiver”: Click on “Connect GPS Receiver”, and the “Config GPS Serial
Port” window would pop up as below (Refer to Figure 4-3-2-1-3).
Please select the suitable “Serial Port” and “Baud Rate” for your
GPS. Click on to connect GPS serial port. Click on
to complete the setting.
Figure 4-3-2-1-3 Config GPS Receiver Serial Port
“Device Wizard”: Click on “Device Wizard” to select appropriate serial port and baud rate to
start the device connection.
“Replay log”: Click on “Replay log” to open the data saved before and play the selected log
data.
*NOTE 1: Before playing the log data, user should go to “File”/ “Disconnect AIS” and “File”/
“Disconnect GPS” to disconnect AIS and GPS.
*NOTE 2: To pause or stop the log play, please go to “File”/ “Pause play” or “File”/ “Stop
play”.
“Exit”: Click on “Exit” to close AMEC AIS Viewer.