User's Manual

31
Step 5: Transceiver Setting
(1) Click on “TRANSCEIVER” tab.
(2) Select the “Enable DSC monitoring” button to enable the DSC function. The factory
default setting is “selected” which means DSC is enabled. The DSC shall be
enabled under normal operation.
(3) Un-select the “Enable DSC monitoring” button if you want to disable DSC monitoring
function. This is not allowed in normal operation.
(4) Select “GPS Output” at “ON” to enable the GPS message transmission. This is
factory default setting and required for normal operation.
(5) Select the “GPS Output” at “OFF” if you want to disable the GPS message
transmission. This is not allowed in normal operation.
(6) Click on to confirm and complete the setting.
(7) To perform other setting, click on specific tab to go further.
(8) To escape from the AMEC AIS Configuration software, click on “EXIT”.
Figure 3-3-5 Transceiver Setting