User's Manual

II
FOR USERS IN THE UNITED STATES OF AMERICA ONLY
WARNING: It is a violation of the rules of the Federal Communications
Commission to input an MMSI that has not been properly assigned to the
end user, or to otherwise input any inaccurate data in this device.
★ The entry of static data into this device shall be performed by the vendor of
the device or by an appropriately qualified person in the business of installing
marine communications equipment on board vessels.
★ Instructions on how to accurately enter and confirm static data in the device
can be found in Section 3.3 of this user manual.
The equipment said in this manual must only be used to which it was designed. Improper
operation or installation may cause damage to the equipment or injury to personnel. AMEC will
not incur any liability of equipment damage or personal injury due to improper use or
installation of the equipment. It is strongly recommended to read this manual and the following
safety instructions before proceeding to installation or operation.
WARNING!
SAFETY INSTRUCTIONS
ELECTRICAL SHOCK HAZARD.
Do not open the case of the
equipment. Only qualified
personnel could work on the interior
of the equipment.
WARNING
TURN OFF THE POWER IMMEDIATELY IF
WATER LEAKS INTO THE EQUIPMENT
OR OBJECT DROPS INTO THE
EQUIPMENT.
Continue operating the equipment could
cause electrical shock or fire. Contact your
nearest distributor for service.
DO NOT DISASSEMBLE OR MODIFY THE
EQUIPMENT.
Improper disassemble or modification could
cause electrical shocks, fire, or personal
injury.
WARNING
DO NOT PLACE ANY LIQUID-FILLED
CONTAINER ON TOP OF THE
EQUIPMENT.
Electrical shocks could be resulted if the
device is contaminated with liquid.
TURN OFF THE POWER
IMMEDIATELY IF THE EQUIPMENT IS
EMMITTING SMOKE OR FIRE.
Continue operating the equipment could
cause electrical shock or fire. Contact
your nearest distributor for service.
EVEN THOUGH THE EQUIPMENT IS
WATERPROOF, PLEASE AVOID
DIRECT CONTACT WITH RAIN OR
SPLASHING WATER.
Electrical shock or fire could be resulted
if water leaks into the equipment.
AVOID OPERATING THE EQUIPMENT
WITH WET HANDS.
Electrical shocks could be resulted if
operating with wet hands.