User's Manual

10
2 Installation
2.1 Installation Procedures
Please familiarize the manual content before installation. Depending on your
hardware configuration, use the following recommended steps to install the device.
1) Mount the device unit to an appropriate location
2) Install VHF antenna
3) Install GPS antenna
4) Connect to a chart plotter via NMEA 0183 and/or other instruments
5) Connect to a chart plotter via NMEA 2000 and/or other instruments
6) Connect to a Tx switch box and/or external alarm system(optional)
7) Connect to an appropriate power source (12V / 24V DC, 2A)
Figure 1 External Connections