User's Manual

General Information

i. Copyright

The entire contents of this instruction manual, including any future updates, revisions, and

modifications, shall remain the property of AMEC at all times. Unauthorized copies or reproduction of

this manual, either in part or whole, in any form of print and electronic media, is prohibited. The

contents herein can only be used for the intended purpose of this manual.

ii. Disclaimer

AMEC is devoted to publish and maintain this product manual. As we continue to improve our AIS

products to satisfy all customers’ needs, information in this document is subject to change without

notice. AMEC does not make any representations or warranties (implied or otherwise) regarding the

accuracy and completeness of this document and shall in no event be liable for any loss of profit or any

commercial damage, including but not limited to special, incidental, consequential, or other damage.

iii. Safety Warning

It is important to know that AIS is designed for the purpose of anti-collision and serves as a

complement to navigation. It is not the absolute navigational equipment and does not replace

any navigational system installed on board.

Any AIS device cannot guarantee monitoring and receiving signals from all vessels in the

surroundings unless those vessels are equipped with AIS devices.

The coastline map in this transponder is neither verified nor approved by Hydrographic

Authorities. It is not an Electronic Chart System and therefore should not be used for

navigation. The information provided by the coastline map is for reference only and should be

used together with other navigation sources and devices.

ELECTRICAL SHOCK HAZARD

Improper disassemble or modification could cause electrical shocks, fire, or personal injury.

Only qualified personnel could work on the interior of the equipment.

MAKE SURE THE POWER SOURCE AND THE POWER INPUT ARE MATCH

Incorrect power sources will damage the equipment and may even result in fire.

Please ensure the correct power input on the adaptor before installation.

AVOID DIRECT CONTACT WITH RAIN OR SPLASHING WATER

Electrical shock or fire could be resulted if water leaks into the equipment.

NOTE/INFORMATION

Important notices and information will be noted in this Installation and Operation Manual