User's Manual

Operation type LCD display Used button Descriptions
Store an FM channel (To automatically/manually save a frequency). In the initial screen,
press the MENU button to get channels automatically stored.
Alternate YES/NO. -> Roll the MENU button up and down.
Select YES/NO. -> Press the MENU button.
When you select “YES”, channels are automatically searched to sequentially go to the index.
Selecting “NO” makes the menu to turn to the next one. To go to the Main menu, press the ESC
button.
* This will make the display turn off with the button lamp blinking. This aims at better Rx
sensitivity.
Select Rx sensitivity (To set frequency sensitivity. In HIGH mode, the MP3 player can detect
frequency with higher sensitivity only, while other frequency may not be detected.) In the
automatic storing menu, press the MENU button to go to Rx sensitivity setting mode.
The options include: HIGH/MID/LOW. Select a desired mode by rolling the MENU button up and
down until the corresponding mode is lit. Then, press the MENU button.
After the setup, the screen will automatically show the next mode.
To go to the Main menu, press the ESC button.
Select FM band (To set frequency bandwidth). This screen initially appears in the FM band
(frequency bandwidth) setting. In the Rx sensitivity menu, press the MENU button to go to the
FM band setting mode, which helps setting of frequency band. You can choose band from either
USA or Japan. The selected band is displayed on the top of the LCD display. How to select one
is the same as that of the Main menu. After the setup, the screen will automatically go to the
next mode.
* USA: 87.5 ~ 108MHz (Same as South Korea)
Japan: 76 ~ 108MHz