Owner`s manual

8
B: PREPARING THE SITE
Figure 9: Loop Diagrams
104886
TOOLS REQUIRED
The following tools and materials are required for proper
installation of the operator:
Two 3/4" wrenches. (For tightening hex nuts on the chain
take-up bolts.)
2. Chain cutting tool. (For adjusting chain length.)
3. Wire cutter, stripper and crimping tools. (For attaching
accessory equipment to the control/mechanical unit
enclosure terminal strip.)
4. Standard screwdriver. (For junction box face plate.)
5. Phillips head screwdriver.
6. Electric arc welder or an electric drill with a 3/8" bit.
The following is a check list of the various parts included with the Tower Plus RS1000 operator:
1. 1 Tower Plus RS1000 Slide Gate Operator
2. w/Cover
3. 2 Gate Warning Sign
4. s
5. 2 Chain Brackets
6. 1 Chain Take-up Bolt Kit
UNPACKING CHECKLIST
C: INSTALLING THE OPERATOR