Technical data

19
3. Lay the PSP Table Mat on a flat surface near the ScanX as shown by Figure
7, View A.
4. As shown by Figure 7, View B, remove the exposed PSP from its washed
and dried envelope as follows:
a. Hold the enveloped exposed PSP, with the printed side facing up, parallel
to and about an inch above the PSP Table Mat.
b. Tear the envelope lengthwise starting at the notch to eject the PSP onto
the PSP Table Mat.
5. As shown by Figure 7, View C, the PSP is now ready to be scanned to read
the image from the PSP by performing the Intraoral Imaging Procedures.
Figure 7. Preparing the Exposed Plate for Scanning
IMPORTANT: Be sure that the sensitive side of the PSP is facing down when
it lands on the PSP Table Mat (See Figure 7, View C). If it is not
sensitive side down, TURN IT OVER IMMEDIATELY. Failure to
do so may result in erasure of the PSP.
Configure the Intraoral Plate Guides. If the desired Plate Guides are not
in place, install these Guides at this time. Do not operate the scanner without
a full complement of two Guides in place. Any combination of Guides may be
used. See Figure 8.
Figure 8. ScanX with a full Complement of Plate Guides in Place.
Scanner Track 2
Plate Guide
Scanner Track 1
Plate Guide
View A
PSP Table Mat
View B
Ejecting PSP to Table Mat
View C
PSPs ready for Scanning
INTRAORAL IMAGING PROCEDURES