Technical data

11
Keypad Control Panel
READY Switch Toggles between the Standby and Ready mode as follows:
1. Press to switch from the Standby mode to the Ready mode.
2. Press and hold down for at least 2 seconds to switch to the
Standby mode from the Ready mode.
Ready/Standby
Green LED indicator
Illuminates green to indicate that the ScanX is Ready for operation.
When extinguished, it indicates that the ScanX is in the Standby mode.
ERASER Switch Toggles between turning the Erase function OFF and ON. This switch
has no effect once the plate scanning or erasing starts.
FLASHING OFF
Blue LED indicator
Illuminates steady blue to indicate that the Erase function is ON and
PSPs will be erased after scanning.
Flashes blue to indicate that the Erase function is OFF and PSPs will
not be erased after scanning.
Scanner Tracks
1 & 2 Indicator
LEDs
Illuminate green when the Scanner has been activated, indicating
that a PSP can be fed into the ScanX track.
Illuminate yellow, indicating the PSP has been sensed and the
Scanner is transporting the PSP in the associated track.
Figure 2. ScanX Duo Front Panel Controls and Indicators
READY
Switch
ERASER
Switch
Keypad Control Panel
Scanner Track 1
Indicator LED
Scanner Track 2
Indicator LED
FLASHING OFF
Blue LED Indicator
Ready/Standby
Green LED indicator
Figure 3. ScanX Duo Rear Panel Controls and Connectors
USB
Connector
Type B
Main Power
Switch (1/0)
IEC
Connector
2A Circuit
Breakers
Item Function
USB Connector
Type B
Provides USB connection
from the computer via the
supplied USB Computer
Connector Cable
Main Power
Switch (1/0)
Controls the application of
ScanX operating power.
2A Circuit
Breakers
Protects against shorts in the
internal electrical circuits.
IEC Connector Provides connection of
Mains outlet power via
supplied line cord.
CONTROLS AND INDICATORS