Technical data
Table Of Contents
- FOREWORD
- TABLE OF CONTENTS
- CONGRATULATIONS
- WARRANTY
- ON-LINE WARRANTY REGISTRATION
- SAFETY NOTICE
- IMPORTANT INFORMATION
- PURPOSE OF THIS MANUAL
- SYSTEM DESCRIPTION
- UNPACKING AND INSPECTION
- COMPUTER SYSTEM REQUIREMENTS
- CONTROLS AND INDICATORS
- TECHNICAL DATA
- ABBREVIATIONS
- SITE SELECTION
- SYSTEM SETUP
- PLATE CARE & PREPARATION
- IMAGING PROCEDURES
- POWERING DOWN THE SYSTEM
- MAINTENANCE
- TROUBLESHOOTING
- ACCESSORIES
9
UNPACKING AND INSPECTION
Unpacking
The ScanX is shipped in a special soft pack transport case (P/N B3975) covered by
a double-wall corrugated over-packaging. Retain the over-packaging to return
the ScanX during future shipping.
Included System Components
The ScanX consists of the model and accessory kit as listed below:
(See TECHNICAL DATA for ratings and identification.)
Description Part Number
Main Portable ScanX 12 ILE Assembly B8120
Soft Pack Transport Case B3975
Accessory Kit containing:
10-Foot Line Cord (See Note) 77243
6-Foot Computer Connector Cable, USB B3554
Instruction Manual B8185
Dust Cover B3903
ScanX Cleaning Sheet Sample Kit B2030
CD Disk Containing Drivers, Utilities and
Instruction Manual
B8108
Inspection
Verify that all listed items were received. If any item is missing, notify your authorized
dealer. Unpack each component of the ScanX and inspect for physical damage
such as scratched panels, damaged connectors, etc. If any damage is noted,
notify your authorized dealer immediately so corrective action can be taken.
Note: The ScanX is equipped with a line cord matching Mains outlet of country of intended
use.
Figure 1. ScanX
12 Portable Digital Imaging System with In-Line Erase