Technical data
Table Of Contents
- FOREWORD
- TABLE OF CONTENTS
- CONGRATULATIONS
- WARRANTY
- ON-LINE WARRANTY REGISTRATION
- SAFETY NOTICE
- IMPORTANT INFORMATION
- PURPOSE OF THIS MANUAL
- SYSTEM DESCRIPTION
- UNPACKING AND INSPECTION
- COMPUTER SYSTEM REQUIREMENTS
- CONTROLS AND INDICATORS
- TECHNICAL DATA
- ABBREVIATIONS
- SITE SELECTION
- SYSTEM SETUP
- PLATE CARE & PREPARATION
- IMAGING PROCEDURES
- POWERING DOWN THE SYSTEM
- MAINTENANCE
- TROUBLESHOOTING
- ACCESSORIES
10
IMPORTANT: To operate the ScanX, it must be connected to a compliant Computer System, and
the computer must be loaded with an authorized Imaging Software. Neither the
Computer System nor the Software is provided by the manufacturer. Contact
your dealer for available Computer System and Software options.
Computer System Recommendations
The Computer System (laptop, computer, monitor, etc.) and any related
peripheral or other equipment, supplied by the user, or a third party, must
comply with the requirements for “Information Technology Equipment" (ITE)
as specified in IEC 60950 (EN 60950).
The minimum computer system requirements necessary to operate the ScanX
are listed below. Items listed with an asterisk (*) are required.
Operating System: * Windows 2000 Professional
for an Intel 32-bit processor with
Service Pack 4 or later, or Windows
XP Professional for an Intel 32-bit
processor with Service Pack 1 and
the KB B22603 update or later.
USB Port: * Must be USB 1.1 or 2.0 or later
CPU: 2.8 GHz Pentium IV
RAM: 1 GB
Hard Drive: * 1 GB available disk space to start
scanning
Monitor SVGA 17”, 1024 x768 or higher
resolution, contrast ratio 450:1,
(1024 x 768 Resolution): .22 dot pitch capability.
For optimum viewing a CRT is rec-
ommended.
Video Display Adapter: 32 MB RAM
Peripherals: * CD ROM Drive
Standard Keyboard & Mouse
Backup Device
External Surge Protector
Power supply backup
Image Management Software: *Authorized software is required
COMPUTER SYSTEM REQUIREMENTS