Technical data

11
COMPUTER SYSTEM REQUIREMENTS
CONTROLS AND INDICATORS
ALLPRO
IMAGING
READY ERASER
FLASHING
OFF
ALLPRO
IMAGING
READY ERASER
FLASHING
OFF
READY
Switch
FLASHING OFF
Blue LED Indicator
ERASER
Switch
Ready/Standby
Green LED indi-
cator
Keypad Control Panel
READY Switch Toggles between the Standby and Ready mode as follows:
1. Press to switch from the Standby mode to the Ready mode.
2. Press and hold down for at least 2 seconds to switch to the
Standby mode from the Ready mode.
Ready/Standby
Green LED indicator
Illuminates green to indicate that the ScanX is Ready for operation.
When extinguished, it indicates that the ScanX is in the Standby mode.
ERASER Switch Toggles between turning the Erase function OFF and ON. This switch
has no effect once the plate scanning or erasing starts.
FLASHING OFF
Blue LED indicator
Illuminates steady blue to indicate that the Erase function is ON and
PSPs will be erased after scanning.
Flashes blue to indicate that the Erase function is OFF and PSPs will
not be erased after scanning.
4 Scanner Track Indicator LEDs
Illuminate green when the Scanner has been activated, indicating that
a PSP can be fed into the ScanX.
Illuminate yellow, indicating the PSP has been sensed and the
Scanner is transporting the PSP.
Keypad Control Panel
4 Scanner Track
Indicator LEDs
System Properties.
If unsure of the operating system version installed,
check that it meets the necessary requirements by
checking the System Properties window.
This is done simply by right clicking the My Computer
icon. Selecting Properties from the menu list displays
the System Properties window as shown. The installed
operating system version is listed under the General tab.
The System Properties window can also be opened
from the Desktop Start button. Just press the Start
button and select SettingsControl Panel and
then click System icon.