Operator`s manual

8
UNPACKING AND INSPECTION
UNPACKING
The ScanX is shipped in a custom Transit Case (P/N 9928-747) covered by a double-wall over-
packaging. The Transit Case meets the specifications of the Air Transport Association (ATA) of
America to provide equipment protection during shipment. A deposit fee has been paid for this
case, which may be returned to ALLPRO Imaging for a full refund of the fee using a Return
Authorization (RA) number, or retained, without refund of the fee, to protect the ScanX in the event
that it is to be transported or shipped in the future. The over-packaging should be used to return
the custom Transit Case to ALLPRO Imaging.
The ScanX consists of the core assembly (PN B2810) and the following accessory kit:
Custom ATA Certified Transit Case (return for deposit refund)
Line Cord (Varies depending on country where used.)
6-Foot High Speed USB Cable, Type A/Type B
In-Counter Installation Kit, P/N B2988
Operator’s Manual
Drivers, Utilities and Manual Disk
USB Installation Notes
INSPECTION
Verify that all listed items were received. If any item is missing, notify your ALLPRO Imaging
authorized dealer. Unpack each component of the ScanX and inspect for physical damage such
as scratched panels, damaged connectors, etc. If any damage is noted, immediately notify your
ALLPRO Imaging authorized dealer so corrective action can be taken.