Operator`s manual

4
SAFETY INSTRUCTIONS
DANGER
AVOID DIRECT
EXPOSURE TO BEAM
LASER RADIATION WHEN OPEN
CAUTION
CLASS 1 LASER PRODUCT
CLASS 3B LASER
RADIATION WHEN OPEN
AVOID EXPOSURE TO BEAM
CLASS IIIb LASER PRODUCT
COVER REMOVED MAKES
THIS DEVICE A
This warning label identifies the ScanX as a Class I Laser a
product and describes the potential danger to humans in the
event the product is opened during authorized service. There
is no laser radiation from this product when operated and
maintained as instructed.
The Laser Product Accession Number is 0212282-00
Alerts users to important Operating
and Maintenance instructions. Read
carefully to avoid any problems.
Warns users that uninsulated voltage
within the unit may be of sufficient
magnitude to cause electric shock.
ATTENTION USERS:
Manufacturing date code on serial number label is in the format: MONTH YYYY.
MEDICAL ELECTRICAL EQUIPMENT
WITH RESPECT TO ELECTRICAL SHOCK, FIRE, MECHANICAL
AND OTHER SPECIFIED HAZARDS ONLY
IN ACCORDANCE WITH UL-60601-1, CAN/CSA C22.2 NO.601.1
66CA
C
L
A
S
S
I
F
I
E
D
Indicates that the ScanX complies to the
Medical Device Directive 93/42/EEC
This equipment has been designed to minimize exposure of personnel to hazards. While the
ScanX is designed for safe operation, certain precautions must be observed. Use of the ScanX not
in conformance with the instructions specified in this manual may result in
permanent failure of the unit.
Knowledge of Warnings and Cautions. Users must exercise every precaution to ensure per-
sonnel safety, and be familiar with the warnings and cautions presented throughout this manual
and summarized below.
In this manual, the following definitions apply for all WARNINGS and CAUTION Statements:
WARNINGS: Any operation, procedure or practice, which, if not strictly observed,
may result in injury or long-term health hazards to personnel.
CAUTIONS: Any operation, procedure or practice, which, if not strictly observed,
may result in destruction of equipment or loss of treatment effectiveness
or damage to equipment and Phosphor Storage Plates (PSPs).
Important Information.
The Power Cord is the main power disconnect device.
The interior of the Main Assembly is only accessible by removing hardware with tools and
should only be opened and serviced by an Authorized ALLPRO Imaging dealer Service
Technician. Failure to heed this warning may result in equipment damage or personal injury,
and
wwiillll vvooiidd aannyy aanndd aallll wwaarrrraannttiieess..
Please contact your authorized ALLPRO Imaging dealer for service information.
MARKINGS