Operator`s manual

MAINTENANCE

The ScanX is designed for many years of trouble-free operation. Maintenance as described

herein is minimal.

CAUTION: Do not use a blower or any forced air devices to remove dust.

Blown dust will only be pushed into the interior optical and

electronic circuits of the ScanX degrading operation.

Use only a vacuum with soft brush attachment to remove dust

from the ScanX exterior or interior as necessary.

Cleaning and Disinfecting the System. Turn OFF the ScanX Main Power Switch,

disconnect the power cord from the Mains wall outlet and disconnect USB cable before cleaning.

Wipe the Scanner outside surfaces with a soft cloth or paper towel dampened with a disinfectant

solution or non-abrasive household cleaner using the following precautions.

 DO NOT SPRAY SOLVENTS OR LIQUID DIRECTLY ON THE SCANNER.

 Be careful not to allow solvents TO RUN OR DRIP into the ScanX.

This could cause damage to the ScanX.

 Allow to air dry before plugging in or turning back on.

Internal System Cleaning. Use a ScanX Cleaning Sheet (P/N B2010 or B2020) to ensure

optimal performance of the ScanX. Perform cleaning in accordance with the procedures provided

by Instruction Sheet, P/N B2018, included with each box of ScanX Cleaning Sheets

Cleaning Phosphor Storage Plates (PSPs). Imaging Plates should be handled

carefully. For the best images, take care not to scratch the PSPs. Keep them dust-free. Perform the

following procedure to clean PSPs:

1. Use lint-free, 100% cotton gauze (not cotton balls). Gently wipe the cotton gauze over

the dry PSP surface. Wipe back and forth and then in a circular motion.

2. To clean any remaining stains, dampen the gauze in anhydrous ethanol and wipe using

the same motion as above.

3. Completely dry the surface by wiping with another piece of cotton gauze. Ensure that the

PSP is completely dry before use.

Disposal of a PSP. Consult with your federal, national, state and local government, for

rules and regulations on disposal of PSPs.

System Turn Off. Removing power from the ScanX by performing the following procedures.

1. Exit from your Imaging Software in accordance with its instructions prior to turning off

the ScanX.

2. Switch the ScanX from ON to Standby by pressing and holding the membrane switch ( )

on the top of the scanner for approximately two seconds, until the green LED below the

switch button goes out.

3. Turn OFF the main power to the ScanX by placing the rocker switch on the Built-In

Control/Connector panel to the OFF (O) position.

IMAGING PROCEDURES