Technical data
Table Of Contents
- FOREWORD
- TABLE OF CONTENTS
- CONGRATULATIONS
- WARRANTY
- ON-LINE REGISTRATION
- SAFETY NOTICE
- IMPORTANT INFORMATION
- PURPOSE OF THIS MANUAL
- SYSTEM DESCRIPTION
- UNPACKING & INSPECTION
- COMPUTER SYSTEM REQUIREMENTS
- CONTROLS & INDICATORS
- TECHNICAL DATA
- ABBREVIATIONS
- SITE SELECTION
- SYSTEM SETUP
- PLATE CARE & PREPARATION
- IMAGING PROCEDURES
- POWERING DOWN THE SYSTEM
- MAINTENANCE
- SCHEDULED MAINTENANCE
- TROUBLESHOOTING
- ACCESSORIES
- IF YOU NEED ASSISTANCE
10
COMPUTER SYSTEM REQUIREMENTS
IMPORTANT: To operate the ScanX, it must be connected to a compliant
Computer System, and the computer must be loaded with an
authorized Imaging Software. Neither the Computer System nor the
Software is provided by the manufacturer. Contact your dealer for
available Computer System and Software options.
Computer System Recommendations
The Computer System (computer, monitor, etc.) and any related peripheral
or other equipment, supplied by the user, or a third party, must comply with
the requirements for Information Technology Equipment (ITE) as specified in
IEC 60950 (EN 60950).
The minimum computer system requirements necessary to operate the ScanX
are listed below. Items listed with an asterisk (*) are required.
Operating System: * Windows 2000 Professional for an
Intel 32-bit processor with Service Pack
4 or later, or Windows XP Professional
for an Intel 32-bit processor with
Service Pack 1and the KB B22603
update or later.
USB Port: * Must be USB 1.1 or 2.0 or later
CPU: 2.8 GHz Pentium IV
RAM: 1 GB
Hard Drive: * 200MB available disk space required
to start scanning
Monitor SVGA 17”, 1024 x768 or higher reso-
lution, contrast ratio 450:1,
(1024 x 768 Resolution): .22 dot pitch capability.
A CRT is recommended for optimum
viewing.
Video Display Adapter: 32 MB RAM
Peripherals: * CD ROM Drive
Standard Keyboard & Mouse
Backup Device
External Surge Protector
Power supply backup
Image Management Software: *Authorized software is required