User manual

GSS Series User Manual
Alloy Computer Products Pty Ltd Copyright ©2007
52
Fig. 3.35
ACL: Automatically generated value, determined by the ACL number.
Rule: Automatically generated number.
EtherType: Select the Ethernet Type from the drop down box provided. Selected
values can be IPv4, Arp, RARP, User Defined 1, User Defined 2, User
Defined 3, None and Any.
Source IP: Enter the Source IP Address for which the rule will be applied to.
Destination IP: Enter the Destination IP Address for which the rule will be applied to.
Protocol: Select the protocol type from the drop down box provided. Selected
values can be ICMP, IGMP, TCP, UDP, User Defined 1, User Defined 2,
User Defined 3, None and Any.
Source Port: Enter the source port of the service you wish to use. Only used when set
to UDP or TCP protocol.
Destination Port: Enter the destination port of the service you wish to use. Only used when
set to UDP or TCP protocol.
Permit: Select whether you want to permit or deny this type of traffic.
Priority: Set a priority level for your ACL rule.
Apply Button: The Apply button must be pressed after making any changes to any of
the values on this screen.