User manual

GSS Series User Manual

3.7.4.2 IP Flow ID Configuration

Packets will be applied a particular Queue level determined by the IP address inside the

Ethernet packet. The packets will then be given a high or low priority based on the queue they

have been assigned to.

Fig. 3.27

IP: Enter a valid IP Address in to the space provided.

Prefix: Enter a prefix value between 1 and 32. This prefix value is the value of

the IP address in bits. If you want a range of IP addresses to be applied

to this rule then you can enter an IP Address and then apply a prefix of

24. Therefore if the IP Address is 192.168.0.x and you have a prefix of 24

then any IP Address of 192.168.0.1 – 192.168.0.254 will be affected.

Source Flow ID: Enter the source flow ID. This ID will be applied to the source address

found inside the packet. Range is 0 – 3.

Destination Flow

ID: Enter the destination flow ID. This ID will be applied to the destination

address found inside the packet. Range is 0 – 3.

Add: Used to create a new IP rule.

Edit: Used to edit an existing IP rule.

Delete: Used to delete an existing rule.