User manual

GSS Series User Manual
Alloy Computer Products Pty Ltd Copyright ©2007
16
ACL QoS Load – Used to load the ACL QoS settings.
User Defined – Used to configure user defined ACL controls.
SNMP – Used to configure SNMP settings.
Link Aggregation – Used to configure link aggregation settings.
Alarm
• Events – Used to enable particular alarm events.
• Email/SMS – Used to configure Email and SMS settings.
Configuration
• Save / Restore – Used to save and restore the configuration of the switch.
• Config File – Used to download and upload the configuration settings of your switch.
Diagnostics
• Diag – Performs diagnostic tests of the switch.
• Loopback – Performs a loopback test on all ports.
• Ping Test – Used to test network connectivity.
Loop Detection – Used to enable Loop Detection.
TFTP Server – Used to enter the IP Address of a TFTP Server.
Log – View system log.
Firmware Upgrade – Used to upgrade the firmware in the switch.
Max Packet Length – Used to set the maximum allowed packet length.
MAC Table
• Information – Displays known MAC Addresses.
• Aging Time – Used to set the MAC aging time of the switch.
• Static Forward – Used to add static MAC address entries.
• Static Filter – Used to configure MAC address filtering.
VLAN
• VLAN Mode – Used to select the desired VLAN mode.
• VLAN Group – Used to configure VLAN groups.
• Port Protocol – Used to configure PVID for different protocol types.
• Port VID – Used to configure the PVID for each port.
Reboot –
Used to save and reboot the switch.
Logout – Used to logout of the web management.