User manual

APS User Manual
96
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.
1.2.4-5 MSTI Ports
This section is used to configure MSTI Port parameters. An MSTI Port is a virtual port and each MSTI
has its own virtual port. The MSTI must be configured before the individual port configuration
options can be applied. This section is much the same as the CIST Port settings but configuration
done here is for each MSTI rather than the CIST.
Web Interface
To configure the MSTI Port Parameters via the Web Interface:
1. Click Configuration, Spanning Tree and MSTI Ports.
2. Select the MSTI you would like to configure and press the GET button.
3. Now you can configure the appropriate port settings for the MSTI.
4. Repeat for all MSTIs.
5. Click the Apply button to save your changes or the Reset button to revert to previous
settings.
Fig. 42 MSTI selection