User manual

APS User Manual

1.2.4-4 CIST Ports

This section is used to configure individual STP Parameters for each port. Here you can enable and

disable STP on individual ports, configure the ports as AdminEdge ports, give certain ports higher

priority than others and much more.

Web Interface

To configure the CIST Port Parameters via the Web Interface:

1. Click Configuration, Spanning Tree and CIST Ports.

2. Select and configure the appropriate settings.

3. Click the Apply button to save your changes or the Reset button to revert to previous

settings.

Parameter Description

Port: Physical port of the switch.

STP Enabled: Select to enable or disable STP on each port.

Path Cost: Controls the path cost incurred by the port. The Auto setting will set the

path cost as appropriate by the physical link speed, using the 802.1D

recommended values. Using a Specific setting, a user-defined value can be

Fig. 41 CIST Port Configuration