User manual

APS User Manual

1.2.4-1 Bridge Settings

This section is used to configure the spanning tree bridge settings, allowing full configuration of all

spanning tree parameters. Here you can select what Spanning Tree Protocol you would like the

switch to use, STP, RSTP or MSTP.

Web Interface

To configure the Bridge Settings for STP via the Web Interface:

1. Click Configuration, Spanning Tree and Bridge Settings.

2. Select the required STP protocol and configure the appropriate basic and advanced STP

parameters.

3. Click the Save button to save your changes or the Reset button to revert to previous settings.

Parameter Description

Protocol Version: Select the appropriate STP protocol, STP, RTP or MSTP.

Default value is MSTP.

Bridge Priority: Controls the bridge priority. The Lower the numeric value the higher the

priority. The bridge priority plus the MSTI instance number, concatenated

with the 6-byte MAC address of the switch forms a Bridge Identifier. For

Fig. 37 STP Bridge Settings