User manual

APS User Manual
81
Parameter Description
Port: Physical port of the switch.
LACP Enabled: Used to enable or disable LACP on the desired port. To enable LACP on an
individual port check the tick box.
Key: The Key is used to determine a specific trunk/aggregation group. The key
can be generated automatically by the switch or you can enter a key
manually. If entering manually valid values are 1 through to 65535. For
multiple ports to belong to the same group the key must be the same on
each port.
Role: The role determines who the port(s) handle LACP traffic. If set to Active the
port will initiate the LACP group, by sending LACP packets to the connecting
device each second. When set to Passive the port will wait to receive LACP
packets from the connecting device.
Reset Button: Used to reset unsaved changes to original configuration.
Apply Button: Used to save the settings configured on this page.