User manual

APS User Manual
73
IP Fragment: Specifies the fragment offset settings for this rule. This involves the settings
for the More Fragments (MF) bit and the Fragment Offset (FRAG OFFSET)
field for an IPv4 frame.
Any: any value is allowed.
Yes: IPv4 frames where the MF bit is set or the FRAG OFFSET field is greater
than zero must match this entry.
No: IPv4 frames where the MF bit is set or the FRAG OFFSET field is greater
than zero must not match this entry.
Default: Any
IP Option: Specifies the options flag setting for this rule.
Any: any value is allowed.
Yes: IPv4 frames where the options flag is set must match this entry.
No: IPv4 frames where the options flag is set must not match this entry.
Default: Any
SIP Filter: Specifies the source IP filter for this rule.
Any: no source IP filter is specified.
Host: specifies the source IP address in the SIP Address field.
Network: specifies the source IP address and source IP mask in the SIP
Address and SIP Mask fields.
Default: Any
DIP Filter: Specifies the destination IP filter for this rule.
Any: no destination IP filter is specified.
Host: specifies the destination IP address in the DIP Address field.
Network: specifies the destination IP address and destination IP mask in the
DIP Address and DIP Mask fields.
Default: Any
Response to take when a rule is matched
Action: Permits or denies a frame based on whether it matches an ACL rule.
Default: Permit
Rate Limiter: Specifies a rate limiter to apply to the port. Range 1 – 16.
Default: Disabled
Port Copy: Defines a port to which matching frames are copied. Range: 1-10.
Default: Disabled
Mirror: Mirrors matching frames from this port.
Default: Disabled
ACL-based port mirroring set by this parameter and port mirroring set on
the general Mirror Configuration page are implemented independently. To