User manual

APS User Manual

Target IP Filter: Specifies the destination IP address.

Any: no target IP filter is specified

Host: specifies the target IP address in the Target IP Address field.

Network: specifies the target IP address and target IP mask in the Target IP

Address and Target IP Mask fields

Default: Any

ARP SMAC Match: Specifies whether frames can be matched according to their sender

hardware address (SHA) field settings.

Any: any value is allowed.

0: ARP frames where SHA is not equal to the SMAC address.

1: ARP frames where SHA is equal to the SMAC address.

Default: Any

RARP DMAC Match: Specifies whether frames can be matched according to their target

hardware address (THA) field settings.

Any: any value is allowed.

0: RARP frames where THA is not equal to the DMAC address.

1: RARP frames where THA is equal to the DMAC address.

Default: Any

IP/Ethernet Length: Specifies whether frames can be matched according to their ARP/RARP

hardware address length (HLN) and protocol address length (PLN) settings.

Any: any value is allowed.

0: ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the

(PLN) is equal to IPv4 (0x04) must not match this entry.

1: ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the

(PLN) is equal to IPv4 (0x04) must match this entry.

Default: Any

IP: Specifies whether frames can be matched according to their ARP/RARP

hardware address space (HRD) settings.

Any: any value is allowed.

0: ARP/RARP frames where the HRD is equal to Ethernet (1) must not match

this entry.

1: ARP/RARP frames where the HRD is equal to Ethernet (1) must match this

entry.

Default: Any

Ethernet: Specifies whether frames can be matched according to their ARP/RARP

protocol address space (PRO) settings.

Any: any value is allowed.

0: ARP/RARP frames where the PRO is equal to IP (0x800) must not match

this entry.