User manual

APS User Manual

following buttons:

Inserts a new ACE before the current row.

Edits the ACE row.

Moves the ACE up the list.

Moves the ACE down the list.

Deletes the ACE.

The lowest plus sign adds a new entry at the bottom of the ACE

listings.

Refresh Button: Used to refresh the values displayed in the ACL section.

Clear Button: Used to clear the selected ALC entry.

Remove All: Used to remove all entries from the ACL list.

Ingress Port, Policy Filter and Frame Type

Ingress Port: Indicates the ingress port of the ACE. Possible values are:

All: The ACE will match all ingress ports.

Port: The ACE will match a specific ingress port.

Policy Filter: Specify the policy number filter for this ACE.

Any: No policy filter is specified. (Policy filter status is "don't-care".)

Specific: If you want to filter a specific policy with this ACE, choose this

value. Two fields for entering a policy value and bitmask will appear, enter

the specific policy ID and bitmask.

(Policy must be created in the Ports Section before it will appear in the list)

Frame Type: Indicates the frame type of the ACE. Possible values are:

Any: The ACE will match any frame type.

Ethernet type: Only Ethernet Type frames can match this ACE. The IEEE

802.3 describes the value of Length/Type Field specifications to be greater

than or equal to 1536 decimal (equal to 0600 hexadecimal).

ARP: Only ARP frames can match this ACE. Notice the ARP frames won't

match the ACE with Ethernet type.

IPv4: Only IPv4 frames can match this ACE. Notice the IPv4 frames won't

match the ACE with Ethernet type.

Filter Criteria based on Selected Frame Type

Ethernet – Mac Parameters

SMAC Filter: The type of source MAC address. Options: Any, Specific

Default: Any